...
This document will provide complete installation instructions for the Demo3 interface board. It is intended for internal Aptina onsemi usage and assumes access to the purchase/request system and internal servers.
...
2. When the installation is complete, power down the system if you need to install a USB 3.0 PCIe adapter card. If installing an ExpressCard adapter the laptop does not need to be shutdown. If the system already comes with a USB 3.0 host adapter skip ahead to Demo3 Assembly.
USB 3.0 Adapter Installation (optional)
...
- It is possible to connect the Demo3 assembly to a USB 2.0 host with either cable. However, performance will be limited to USB 2.0 bandwidth. This usage is not recommended, but may be useful for troubleshooting issues with the USB 3.0 host.
...
Demo3 Driver Installation
Once connected, the Windows operating system will detect the Demo3 and attempt to install an appropriate driver. If one is not found, it will prompt for a driver location. 
to the locations noted earlier and path to the folder that suits the flavor of Windows you use (Windows7 dialogs shown): 
| Anchor | ||||
|---|---|---|---|---|
|
...
Tip #2: Windows7 will attempt to search the Windows Update site for a driver. If your system is behind the Aptina onsemi corporate firewall, Windows Update will be blocked and this action will eventually timeout and fail. To save a few minutes of your time, click the bubble that appears on the taskbar:
Next click "Skip obtaining driver software from Windows Update":
Click "Yes" on the "Driver Software Installation" dialog:
Then begin the "Update Driver Software…" process described in Tip #1.
Tip #3:
The Demo3 Team has uploaded Windows7 drivers for the Demo3 to the Windows Update site. Users, who have internet access that does not block the Windows Update site, will automatically have drivers installed for them.
Tip #4:
To confirm the Demo3 driver installation:
- Run the Device Manager.
- Expand the "Universal Serial Bus controllers" section.
- Then check for the "Aptina onsemi Demo3" (making note of any error codes/warnings):
...
Please contact Email imaging_demo_bugs@aptinabugs@onsemi.com.
History
...
(AC) Initial document
...
9/13/2012
...
(JM) Added name to footer, including the version.
...
12/11/2012
...
(AC) Additional info to "Demo3 Attachment" section, some minor rewording for clarification in other sections.
...
1/17/2013
...
(JM) Removed internal references.
...