...
- In Software Simulation mode, the Distortion Correction output format can be specified via Format: in the Output Mode group. Three modes supported: NTSC, PAL and Progressive. In SOC Hardware the output format is determined by the sensor settings and it can be modified by the DevWareX sensor control pages.
- In Software Simulation mode the Distortion Correction effect can be seen more clearly by selecting Circle Overlay, ten circles with different image heights will be shown on the current frame sensor output, check Enable and you can see what will happen to those circles after Distortion Correction processing. Check Open picture-in-picture if you want to see both images before and after Distortion Correction at the same time. These options are available in Software Simulation mode only.
- The Distortion Correction Tool provides a default distortion correction setting for the Marshal wide angle lens. You can import a different setting by click Load Settings… or save the current settings for later use by click Save Settings…
- Use Save Data... to save only the Calibration Data. On the Timiing, you can use Write to INI file... to save all settings in a DevWareX INI file format.
You can find default settings which come with the tool in the folder
<installation-path>\Plugins\Default Lens Correction
You can apply the current Distortion Correction tool setting to either the software simulator or to the sensor by clicking the corresponding radio box at the bottom of Distortion Correction Tools, and then click on Apply button. If Software Simulation is selected, make sure Enable gets checked so that the new Distortion Correction setting can take effect in the DevWareX display window.
...