Excerpt |
---|
DevWareX is a multi-platform implementation of DevWare, created with a more flexible GUI-generation tool. It has the same layout and controls as DevWare, but with additional features. |
...
Auto SW download - applies only to External DevWareXAnchor AutoSW AutoSW - This feature allows for part identification even when the part-specific SDAT file isn't present.
- If the part is recognized and its SDAT file is missing, the user is prompted with a link to the SW installer location on the download Web site and given the choice of being taken there.
Zoom stays centeredAnchor ZoomCentered ZoomCentered - When the image is zoomed-in past 100% and the "Image" dialog is enabled, the user is presented with a box that can be moved to navigate within the image.
- Zooming in and out then stays centered to this position, not the direct center as done in DevWare (from the upper-left corner).
Zoom increment and specific values can be enteredAnchor ZoomInc ZoomInc - To sent the increment %, in the "Options" dialog use the "Zoom Incremental" (from 5% to 50%).
- To set a specific zoom value, use the pull-down from the Menu bar item "Zoom In" (from 2% to 1600%).
- To sent the increment %, in the "Options" dialog use the "Zoom Incremental" (from 5% to 50%).
Zoom to PixelAnchor ZoomPixel ZoomPixel - The mouse scroll wheel can zoom in to the Pixel value level.
- Use the "Mouse Selection / Point" to select the desired Pixel, which results in the width/height location and the "cross-hair" of the Pixel.
- Use the "cross-hair" location to follow the Pixel as you zoom in to the Pixel value.
- Use the "Options" dialog to show the pixel values in Hex.
Options Menu reorganizedAnchor OptionsMenu OptionsMenu - Sensor-specific items are now in Diagnostics/Sensor Advanced dialog.
...
Register Dialog; select which pages appear on the TabsAnchor RegPages RegPages - By use of a "Push-Pin" on the Page tab, you can select which Tabs will stay displayed.
- A maximum of 6 tabs can be pinned, with on tab being non-pinable.
Export SHIP LogAnchor ExportShipLog ExportShipLog - Enables the ability to filter the SHIP log by address and Read/Write - used to capture the registers settings for a given configuration.
- In the "Options" dialog, deselect "Allow Info Panel to Poll Registers".
- Enable "SHIP", and run the INI file preset with the configuration you want to record.
- Select "Export SHIP Log" - the settings are presented in "Wizard" dialog.
- Select the ship address of the sensor if you need sensor-only, or leave all of them to get Demo3 and SERDES.
- Deselect "Read", then select Next and then "Save to File ..." to output the results in as an INI file.
...