Excerpt |
---|
DevWareX is a multi-platform implementation of DevWare, created with a more flexible GUI-generation tool. It has the same layout and controls as DevWare, but with additional features. |
...
- Auto SW download - applies only to External DevWareX
- This feature allows for part identification even when the part-specific SDAT file isn't present.
- If the part is recognized and its SDAT file is missing, the user is prompted with a link to the SW installer location on the download Web site and given the choice of being taken there.
- Zoom stays centered
- When the image is zoomed-in past 100% and the "Image" dialog is enabled, the user is presented with a box that can be moved to navigate within the image.
- Zooming in and out then stays centered to this position, not the direct center as done in DevWare (from the upper-left corner).
- Zoom increment and specific values can be entered
- To sent the increment %, in the "Options" dialog use the "Zoom Incremental" (from 5% to 50%).
- To set a specific zoom value, use the pull-down from the Menu bar item "Zoom In" (from 2% to 1600%).
- Zoom to Pixel
- The mouse scroll wheel can zoom in to the Pixel value level.
- Use the "Mouse Selection / Point" to select the desired Pixel, which results in the width/height location and the "cross-hair" of the Pixel.
- Use the "cross-hair" location to follow the Pixel as you zoom in to the Pixel value.
- Use the "Options" dialog to show the pixel values in Hex.
Anchor |
---|
OptionsMenu | OptionsMenu - Options Menu reorganized
- Sensor-specific items are now in Diagnostics/Sensor Advanced dialog.
...
The "LSB Aligned" and "Middle 12" check boxes on the Sensor Control -> Diagnostics -> Sensor Advanced dialog page. None of the controls on this dialog page affect sensor registers. They control Demo board modes and the interpretation of the pixel data from the camera.
...
- Register Dialog; select which pages appear on the Tabs
- By use of a "Push-Pin" on the Page tab, you can select which Tabs will stay displayed.
- A maximum of 6 tabs can be pinned, with on tab being non-pinable.
Anchor |
---|
| ExportShipLog |
---|
| ExportShipLog |
---|
|
Export SHIP Log- Enables the ability to filter the SHIP log by address and Read/Write - used to capture the registers settings for a given configuration.
- In the "Options" dialog, deselect "Allow Info Panel to Poll Registers".
- Enable "SHIP", and run the INI file preset with the configuration you want to record.
- Select "Export SHIP Log" - the settings are presented in "Wizard" dialog.
- Select the ship address of the sensor if you need sensor-only, or leave all of them to get Demo3 and SERDES.
- Deselect "Read", then select Next and then "Save to File ..." to output the results in as an INI file.
...