...
It also presents some operational notes.
If you want to program an existing binary file, simply select the "Generate Image and Program" tab.
...
Sensor Data File (.xsdat or .sdat)
...
1.3.3 Program Memory Device
Start Address - Specify the flash address to beging writing the image to.
Erase Before Writing - The flash This dialog is used to write a binary file to the attached device using the parameters in the "Configure Memory Device" section.
Note: the fields will be greyed-out if no device is attached.
Start Address - Specify the flash address to begin writing the image to.
Erase Before Writing - The flash device content will be erased prior to programming the new content into it. Uncheck to suppress erasing the flash device content, this may be desirable if the area in the address space of the device has been erased before.
Program Image into Flash - Select the button to write an existing image to flash.
In order to perform this operation, a Demo2/Demo2X camera with the correct headboard and a supported flash device must be connected to your computer.
1.3.3.1 Post Program
Use the "Verify" button to compare the binary file data to what has just been write to the device.
Use the "Reset Sensor" button to perform a Reset procedure on the attached device.
...
Read Image from Flash (Internal only version)
Select the button to read the flash memory image and save it to a binary (.bin) file.
...
Generate Configuration from Image (Internal only version)
Select the button to convert a binary (.bin) file into a Configuration (.fcfg) file.
...