...
Via the DevWareX “Register All Access”
Start DevWareX and Detect or load the sensor SDAT file. Under “View”, select “Register All Access (Peek & Poke)”. This will start the dialog as a Tab under the Register dialog. Use the “Any Device Register” section and enter the data in the much the same manner as regpoke.exe.
...
Navigate to the vendor-specific sub-folder in “\aptina imaging\apps_data\Serdes”.
Copy “SERDES_template.cdat” to the “board_data” folder under the installation folder.
Edit that .cdat file as described in the header and by following the examples for registers and bit-fields.
Start DevWareX and Detect or load the sensor SDAT file.
Enable the Register dialog, use the “Page:” pull-down to select the “CHIPNAME” as defined in the CDAT.