...
Start DevWareX and load the sensor SDAT file. Under “View”, select “Register All Access (Peek & Poke)”. This will start the dialog as a Tab under the Register dialog. Use the “Any Device Register” section and enter the data in the much the same manner as regpoke.exe.
Via a CDAT file
This method takes the most effort, but has the advantage of being able to define the SerDes registers by name and then access them via the DevWareX Register dialog. To use this method, do the following:
Navigate to the vendor-specific sub-folder in “\aptina imaging\apps_data\Serdes”.
Copy “SERDES_template.cdat” to the “board_data” folder under the installation folder.
Edit that .cdat file as described in the header and by following the examples for registers and bit-fields.