...
- Start DevWareX and "Probe" to identify the part. When the "Startup Wizard" dialog appears, deselect all options and select "Finish".
- Set Register 0x20 bit 5 to 1; this will disable access to the Flash/EEPROM.
- Toggle Register 0x1A bit 0 on/off; this preforms a soft reset on the sensor.
- Verify that Register 0x1C = 0x3000; indicates a successful reboot. Leave DevWareX running.
Note: Register 0x1C is "Reserved" and can only be read via "View / Register All Access (Peek & Poke) / Simple Register". - Run FlashTool and attempt to program the Flash/EEPROM.
- Select "Verify" to ensure the binary was programmed correctly.
- Go back to DevWareX and clear Register 0x20 bit 5 and toggle Register 0x1A bit 0 on/off.
- From the Command Menu item, select "Check Sensor State", then select "Play" - you should see a stream image.
...