...

Introduction

Aptina onsemi Demo System sensor headboards have an 8KB EEPROM which can be used to store information for that particular headboard.
This document describes what kinds of data can be stored in the EEPROM, and how to use the software tools.

...

miprom –label "name" –pga filename.ini
Only the first preset in the ini file is loaded. If there is already a PGA record with same label, the old record is replaced with the new one. The –label parameter must come first.
Settings created by Aptina onsemi when the headboard is manufactured will use the label "FACTORY". The factory settings are unique to each individual headboard, so you should be careful not to alter or remove them.

...

miprom –label "name" –swpga filename.ini
Only the first preset in the ini file is loaded. If there is already a PGA record with same label, the old record is replaced with the new one. The –label parameter must come first.
Settings created by Aptina onsemi when the headboard is manufactured will use the label "FACTORY". The factory settings are unique to each individual headboard, so you should be careful not to alter or remove them.

...

miprom –label "name" –ccm filename.ini
Only the first preset in the ini file is loaded. If there is already a CCM record with same label, the old record is replaced with the new one. The –label parameter must come first.
Settings created by Aptina onsemi when the headboard is manufactured will use the label "FACTORY". The factory settings are unique to each individual headboard, so you should be careful not to alter or remove them.

...

miprom –label "name" –swccm filename.ini
Only the first preset in the ini file is loaded. If there is already an SWCCM record with same label, the old record is replaced with the new one. The –label parameter must come first.
Settings created by Aptina onsemi when the headboard is manufactured will use the label "FACTORY". The factory settings are unique to each individual headboard, so you should be careful not to alter or remove them.

...

miprom –label "name" –swstereo filename.ini
Only the first preset in the ini file is loaded. If there is already an SWSTEREO record with same label, the old record is replaced with the new one. The –label parameter must come first.
Settings created by Aptina onsemi when the headboard is manufactured will use the label "FACTORY". The factory settings are unique to each individual headboard, so you should be careful not to alter or remove them.

...